Profiles are glued to a dry surface cleaned of dust and fat, with the use of available glues for sealing nettings with an addition of an elastic emulsion. (Elastic emulsion ATLAS, Emulsion BOLIX EL). The installation should take place in a temperature between +5 and +30 degrees Celsius. A plastered, not insulated wall or an insulation performed by using a slightly wet method and finished by a thin-layered plaster may be used as a surface. The best effect of fastening can be obtained by using a strip and point method of gluing, only for flat surfaces applying of a uniform layer of glue by a serrated trowel is recommended. In the case of combining profiles at their length and in the corners, it is necessary to remember about gluing the head of the trims with a 2mm layer of glue with an addition of an elastic emulsion. After combining the surfaces of the profiles with the base, tanning the joints and priming the surface, one can start painting with elevation paints with the use of a roller or a brush. Mineral, acrylic and etc. plasters can also be applied to profiles.